AudiA4 - Video tutorial. In today's video tutorial we will see a solution on how to reset the brake pad wear warning light on an Audi A4 B7; before carrying out the operation it is necessary to replace the worn brake pads. Then we go to remove the front wheels and disconnect the electrical connector of the brake pad sensor; we also remove the Operation Service reset procedure on the Audi A4 B7 Let's see in this short and simple video the instructions that will allow us to reset the service light of the RNSE hidden menu access procedure. Turn the key to II position and wait for the RNS-E system to start. Press and hold VOLUME/POWER knob to turn off the system. Turn on the system again. Press NAV button. Press and hold upper-left soft button for 5 seconds. Press and hold upper-right soft button. After few seconds RNS-E hidden Tomake sure the indicator has been reset, start the engine. On a 2016 Audi A4, how do you reset the service light? Reset of the 2016 Audi A4/S4 service interval. Start the car. To access the SERVICE INTERVAL DISPLAY, press the CAR button. You should choose RESET OIL CHANGE INTERVAL. To access the CAR SYSTEMS, press the CAR button.

Fora maintenance light: Check your owners manual if you have it. There is most likely a simple "end user" procedure for resetting the light. If you don't have the owner's manual, try googling for "audi a4 service light reset". There are several results but it's not clear to me whether they are only applicable to certain years of the A4.

Pressand hold the Spanner button, while turning the ignition on (position 2) Release the Spanner button. “SERVICE” should now appear on the display. Press and hold the 0,0 button until the display shows “SERVICE IN xxxx Miles / Kilometres”. Release the 0,0 button, then turn off the ignition. This site uses Akismet to reduce spam.
. 282 25 85 42 395 362 161 139 137

audi a4 b7 service reset